Main Menu

 New England Micro Rappel Kit                                      

Product Description:
Originally designed for US Military Special Forces, the Micro Rappel System is a compact, lightweight two-mode system that converts from a belt to a harness in seconds. The system consists of a rappel harness, descender, 2 carabiners, deployment bag, usage log, instruction sheet, and 82 feet of 5mm tech cord with chafe guard--providing the means to escape from any potentially volatile situation.

Features:

• Compact
• lightweight
• easy to deploy

Applications:  Emergency Escape System

Colors Available: BLACK

Sunlight/UV:
Very little degradation from sunlight. Can be used outside over long term if inspected regularly.

Heat:
Polyester melts at 480°F with progressive strength loss above 300°F. Technora melts at 1200' F.

Dielectrics:
Good resistance to the passage of electrical current. However, dirt, surface contaminants, water entrapment, and the like can significantly affect dielectric properties. Extreme caution should be exercised any time a rope is in the proximity of live circuits.

Working Loads:
No blanket safe working load (SWL) recommendations can be made for any line because SWL's must be calculated based on application, conditions of use, and potential danger to personnel among other considerations. It is recommended that the end user establish working loads and safety factors based on best practices established by the end user's industry; by professional judgment and personal experience; and after thorough assessment of all risks. The SWL is a guideline for the use of a rope in good condition for non-critical applications and should be reduced where life, limb, or valuable property is involved, or in cases of exceptional service such as shock loading, sustained loading, severe vibration, etc. The Cordage Institute specifies that the SWL of a rope shall be determined by dividing the Minimum Tensile Strength of the rope by a safety factor. The safety factor ranges from 5 to 12 for non-critical uses and is typically set at 15 for life lines.

Splicing Instructions:
Not Applicable